| 1. | This is shown by the curves in fig. 3. 53 which are for several indicated values of the peak overpressure .
图353中关于某些指定超压值的曲线就表明这种情况。 |
| 2. | Relative tolerance between forward and backward in indicating value
示值进回程相对误差 |
| 3. | Tolerance between forward and backward in indicating value
示值进回程差 |
| 4. | Continuously variable to 1 2 . 5 or less panel indicate value
连续可变,至面板指示值的1 2 . 5或以下 |
| 5. | Relative variation in the indicating value
示值相对变动值 |
| 6. | Variation in the indicating value
示值变动值 |
| 7. | Check if the indicating value is lf nzero - position on the gauge dial before fitting
仪表在安装前应检查仪表示值是否在零位。 |
| 8. | If the specified variable already exists , it will simply be assigned the indicated value
如果指定变量已经存在，则简单地将所指明的值赋给它。 |
| 9. | This is shown by the curves in fig . 3 . 53 which are for several indicated values of the peak overpressure
图3 53中关于某些指定超压值的曲线就表明这种情况。 |
| 10. | Observe the pressure differential gauge . if there is a decrease in the indicated value , the no . 1 check valve is reported as leaking
观察压差表。如果指示值有下降，则1号止回阀就报告为泄漏。 |
